Step One - Set up
Firstly set up tools and equipment and check all PPE. Set up a power lead running from a power point or power box
Step two - Top & Bottom Plates
·First determine the wall length using a tape measure and mark the top and bottom plate with a pencil a line where the measurement is on the top and bottom plates
· Cut the top and bottom plates using a drop saw
· Lay the top and bottom plate on the concrete flooring with the edges up and ends flush
· Mark stud locations with a tape measure, square and a pencil.
· Draw a line with the square and pencil across both studs.
· Cut the top and bottom plates using a drop saw
· Lay the top and bottom plate on the concrete flooring with the edges up and ends flush
· Mark stud locations with a tape measure, square and a pencil.
· Draw a line with the square and pencil across both studs.